# This file contains common pin mappings for the bigtreetech adxl345 v2.0
# To use this config, the firmware should be compiled for the
# RP2040 with "USB"
# The micro-controller will be used to control the components on the nozzle.
#
#    Bus 008 Device 002: ID 1d50:614e OpenMoko, Inc. rp2040
# See docs/Config_Reference.md for a description of parameters.

[mcu btt_adxl345]
serial: /dev/serial/by-id/usb-Klipper_rp2040_454741505B88249A-if00

[adxl345]
cs_pin: btt_adxl345:gpio9
#spi_bus: spi1a
spi_software_sclk_pin: btt_adxl345:gpio10
spi_software_mosi_pin: btt_adxl345:gpio11
spi_software_miso_pin: btt_adxl345:gpio8
axes_map: z,x,-y

[resonance_tester]
probe_points: 100, 100, 20
accel_chip: adxl345